LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 522 (3.2L - Crankshaft & Cylinder Block - Engine Code: CALA (Sedan)) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Transmission Side >> Drive Plate, Removing And Installing >> Installing

Drive Plate, Removing And Installing: Installing

WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the drive plate bolts.

In vehicles with a manual transmission or the multitronic transmission 0AW, there is a needle bearing in the drive plate. Do not insert a needle bearing in vehicles with the automatic transmission 0B6. Check if the needle bearing is inserted before installing. Remove needle bearing from drive plate and install. Refer to NEEDLE BEARING IN DRIVE PLATE, REPLACING .

-- Be careful of the alignment bushings during installation.

-- Turn the Counterhold - Flywheel 10-201 to tighten the bolts.

scientia non olet · About LEMON Manuals