Balance Shaft, Removing And Installing: Installing
WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Tightening specifications. Refer to OVERVIEW - BALANCE SHAFT and Figure.
- Secure crankshaft -1- in "TDC" position using Crankshaft Locking Pin T40069.
Install in reverse order of removal. Note the following:
NOTE:
The balance weights can only be positioned one way on balance shaft.
-- Install the power take-off drive chain. Refer to POWER TAKE-OFF DRIVE CHAIN, REMOVING AND INSTALLING .
-- Install the timing chain cover lower section. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .
-- Install the belt pulley side sealing flange. Refer to SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .
-- Fill the engine oil and check the oil level. Refer to ENGINE OIL, CHECKING LEVEL .