Needle Bearing In Drive Plate, Replacing: Procedure
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, and 2013 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is removed. Refer to TRANSMISSION, REMOVING AND INSTALLING (0B6) or TRANSMISSION, REMOVING (0BK), TRANSMISSION, INSTALLING (0BK).
- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
- Place the -40-103- under the drive plate to remove and install.
- Press out the needle bearing using the -VW421- and workshop press.
- The smaller diameter of the -VW421- faces the drive plate.
- Carefully press the needle bearing in all the way using the - VW418A- and workshop press.
- Installed position: the closed side of the needle bearing faces the engine.
- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING