Oil Pump And Suction Jet Pump, Removing And Installing: Installing

Fig 1: Wrapping Tape Around Input Shaft Splines

Courtesy of AUDI OF AMERICA, LLC

• Tightening specifications. Refer to OVERVIEW - TRANSMISSION .

-- Wrap the splines for the outer drive axle with adhesive tape in direction of -arrow-, so that the inner surfaces of the suction jet pump are not damaged when installing.

-- Coat the tape lightly with grease.

-- Push the O-ring -2- onto the seal seat on the suction jet pump -1-.

Fig 2: Installing Suction Jet Pump Seal Seat O-Ring

Courtesy of AUDI OF AMERICA, LLC

-- Check the sealing surface -arrow- on the inside of the large opening in the suction jet pump for damage and replace if necessary.

Fig 3: Checking Sealing Surface -Arrow- On Inside Of Large Opening In Suction Jet Pump For Damage

Courtesy of AUDI OF AMERICA, LLC

-- Check that the small O-rings -1- are in the correct places on the suction jet pump.

-- Push the suction jet pump -2- and oil pump -1- separately onto the input shaft.

Fig 4: Identifying Oil Pump Removed

Courtesy of AUDI OF AMERICA, LLC

-- Position the suction jet pump on the oil pump and tighten the bolts -arrows-.

-- Tighten the oil pump -arrows-.

Fig 5: Removing Bolts And Pushing Oil Pump Forward On Input Shaft

Courtesy of AUDI OF AMERICA, LLC

Installation is performed in reverse order of removal.

Fig 6: Wrapping Tape Around Input Shaft Splines

Courtesy of AUDI OF AMERICA, LLC

-- Remove the adhesive tape.

-- Install the DSG Transmission Mechatronic -J743-. Refer to MECHATRONIC, REMOVING AND INSTALLING .

-- Install the dual clutch. Refer to DUAL CLUTCH, INSTALLING .

-- Install the flywheel. Refer to FLYWHEEL, REMOVING AND INSTALLING .