Overview - Transmission
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2018 Audi S6, 2017 Audi S6, 2016 Audi S6, 2016 Audi S4, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- Oil Guide
- For the input shaft
- Transmission Intermediate Housing
- With wheel set
- Gear Position Seal
- Only replace if damaged
- Removing and installing. Refer to Fig 2.
- Front Oil Catch Tray
- Replace after removal
- Clipped onto the Sensor Module --
- Sensor Module --
- With integrated Transmission Input Speed Sensor 2 -G612-, Transmission Input Speed Sensor 1 -G632-, Drive Position Sensor -G676- and Circuit Board 3 --
- There are different versions depending on the date of manufacture.
- Removing and installing. Refer to Sensor Module --, WITH INTEGRATED TRANSMITTERS AND SENSORS -G612-, -G632-, -G676 - AND Circuit Board 3 --, REMOVING AND INSTALLING .
- Bolt
- 8 Nm
- There are different versions depending on the date of manufacture.
- Bolt
- 4.5 Nm
- O-Ring
- Replacing
- O-Ring
- Replacing
- Bolt
- 25 Nm
- Quantity: 5
- Oil Pump
- Removing and installing. Refer to OIL PUMP AND SUCTION JET PUMP, REMOVING AND INSTALLING .
- Suction Jet Pump
- Replace the small O-ring (not shown in the illustration)
- Shaft Seal
- The Double seal is connected
- For the separating wall inside the transmission housing
- Replacing. Refer to TRANSMISSION HOUSING SEPARATOR SEALS, REPLACING .
- Connector Housing for the Sensor Module --
- Removing and installing. Refer to Sensor Module --, WITH INTEGRATED TRANSMITTERS AND SENSORS -G612-, -G632-, -G676 - AND Circuit Board 3 --, REMOVING AND INSTALLING .
- Transmission Housing
- Oil Guide
- To the front final drive
- Bolt
- Replacing
- Tightening specification and sequence. Refer to Fig 3.
- Side Shaft
- With helical gear wheel
- Bolt
- 150 Nm +90°
- Replacing
- For the side shaft to the pinion
- Spur Gear
- Needle Bearing
CAUTION:
There is a risk of damaging the gear position
- Do not use any sharp-edged tools when removing the seals.
-- Remove the seal by hand from the respective gear position -2-.
-- Coat the new seal -1- with MTF and install on the Seal Installer - Gear Selector T40291.
-- Place the Seal Installer - Gear Selector T40291 on the respective gear position -2- and insert the seal -1-.
NOTE:
Replace the bolts.
-- Tighten the bolts in two stages as described below:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -Arrows- | 8 Nm diagonally |
| 2. | -Arrows- | 120° additional turn diagonally |