Securing On Engine And Transmission Holder
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2018 Audi S6, 2017 Audi S6, 2016 Audi S6, 2016 Audi S4, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Engine And Transmission Holder VW6095
- Holding Plate VW309A
- Hook And Support Tool T40197
- Hook and Support Tool T40294
CAUTION:
Do not use the Hook And Support Tool T40197 for the repair (Refer to Sensor Module --, WITH INTEGRATED TRANSMITTERS AND SENSORS -G612-, -G632-, -G676 - AND Circuit Board 3 --, REMOVING AND INSTALLING ) - There is a risk of injury.
Only use the Hook and Support Tool T40294 for this operation.
Procedure
- Hold the transmission with the Shop Crane VAS6100. Refer to TRANSMISSION, TRANSPORTING .
-- Attach the Holding Plate VW309A to the Hook And Support Tool T40197.
-- Place the transmission using the Shop Crane VAS6100 in the Engine And Transmission Holder VAS6095.
NOTE:
The vents for the transmission housing and final drive must be closed before turning a filled transmission with oil pan upward on the engine and transmission holder.