Oil Pan, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2018 Audi S6, 2017 Audi S6, 2016 Audi S6, 2016 Audi S4, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Noise Insulation Panels

Courtesy of AUDI OF AMERICA, LLC

NOTE:

General Repair Instructions. Refer to REPAIR INFORMATION .

Rules for cleanliness when working on the DSG transmission. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

The Transmission is Installed.

It is also possible to remove and install the ATF pan when the transmission is installed. Depending on the vehicle model and the engine version, additional work may be required to be able to reach the ATF pan. Refer to Mechatronic, Removing and Installing

Transmission Removed.

-- The transmission is secured to the engine/transmission holder. Refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .

-- Place the Used Oil Collection and Extraction Unit SMN372500 under the transmission.

-- Drain the ATF. Refer to ATF, DRAINING AND FILLING .

-- Diagonally Loosen the screws -1 through 15-.

Fig 2: ATF Oil Pan And Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts and the ATF pan.

NOTE:

Ignore -arrows-.