Shift Lock Solenoid -N110-: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Audi A4 Quattro, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order, paying attention to the following:

Tightening specification, refer to SELECTOR MECHANISM OVERVIEW .

-- Turn the ball head -1- into the correct installed position.

-- Install the shift lock solenoid at an angle into the selector mechanism and then tilt it opposite the direction of -arrow-.

The ball head -1- must engage completely in the operating lever on selector mechanism. Press it down using a small screwdriver if necessary.

Fig 1: Pressing Retaining Hooks Into Shift Mechanism
Courtesy of AUDI OF AMERICA, LLC

-- Attach the shift lock solenoid to the hook -A-.

-- Position the cover -A- over the shift lock solenoid and carefully lock it in -1 through 3-.

Fig 2: Identifying Shift Mechanism

Courtesy of AUDI OF AMERICA, LLC

-- Connect the electrical connectors.

-- Check the shift mechanism function before completing assembly. Refer to SELECTOR MECHANISM, CHECKING .

-- Install the front ashtray. Refer to FRONT ASHTRAY, REMOVING AND INSTALLING .