Selector Mechanism Overview
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Audi A4 Quattro, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
There is a risk of injury and accident from accidentally engaging a gear when the engine is running.
- Before working on a running engine, move the selector lever to P and push the parking brake button in order to lock the electro-mechanical parking brake.
Before disassembling the selector mechanism, perform check. Refer to SELECTOR MECHANISM, CHECKING .
- Selector Lever Handle
- Decorative Ring
- Selector Lever Boot
- Clamp
- Selector Lever Transmission Range Position Display -Y26-
- Nut
- 10 Nm
- Quantity: 4
- For securing the selector mechanism to the body
- Seal
- Selector Lever Sensor System Control Module -J587- with Tiptronic Switch -F189-
- Selector Mechanism Function Unit
- Can only be replaced as a unit
- Refer to SHIFT MECHANISM FUNCTION UNIT
- Shift Lock Solenoid -N110-
- Refer to Shift Lock Solenoid -N110-
- Transmission Park Selector Switch -F305-
- Consists of two microswitches on the circuit board on the shift lock solenoid
- Can only be replaced together with the shift lock solenoid, refer to Shift Lock Solenoid -N110-
- Noise Insulation
- Not on all vehicles
- Lock Washers
- Quantity: 4
- Replace
- For securing the noise insulation to the shift mechanism function unit
- Retaining Clip
- Secures selector lever cable on selector mechanism function unit
- O-ring
- Replace
- Selector Lever Cable
- Do not bend
- Refer to SELECTOR LEVER CABLE OVERVIEW
- Cover
- Over the shift lock solenoid