Ribbed belt, removing and installing: Installing

WARNING: This page is about a different car, the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in reverse order of removal, note the following:

Fig 1: Placing Ribbed Belt Over Belt Pulley

GW00017907

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Place ribbed belt over belt pulley as shown in the illustration.
Generator
Idler roller
Coolant pump

Power steering pump
Air conditioner compressor
Tensioning device for ribbed belt
Crankshaft

NOTE:

When installing the ribbed belt, make sure it is seated correctly on the pulleys.

Install lock carrier with attachments →
- 50 BODY, FRONT
- 50 - BODY - FRONT for BODY EXTERIOR - CABRIOLET
.
Start engine and check belt running.
Install front bumper cover →
- 63 BUMPER
- 63 - BUMPERS for BODY EXTERIOR - CABRIOLET
.