Adaptive Cruise Control Sensor -G550-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Installation is the reverse of removal, with special attention to the following:

NOTE:

The stud bolts in the bracket are preset. If necessary, correct the setting.

-- Place the Adaptive Cruise Control Sensor -G550- on a soft, clean cloth.

Fig 1: Identifying Dimension -A- To All Studs

Courtesy of AUDI OF AMERICA, LLC

Dimension -a- must be 43 mm.

-- Insert bracket and tighten bolts.

-- Inset the Adaptive Cruise Control Sensor -G550- and carefully push the nuts onto the threaded pins in the sensor.

RS Models:

-- Install the air guide to the coolant auxiliary cooler. .

-- Install the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

All Models:

-- Install the air intake grille. Refer to OVERVIEW - BUMPER COVER .

-- Calibrate the adaptive cruise control. Refer to ACC, CALIBRATING, CALIBRATION PROCEDURE WITH Setting Device Basic Set VAS6430/1 .