LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 486 (Bumpers (Sedan)) >> 63 Bumpers >> Front Bumper >> Impact Member Bracket, Removing And Installing >> Impact Member Bracket, Removing And Installing, Vehicles From My 2013 >> Installing

Impact Member Bracket, Removing And Installing, Vehicles From My 2013: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Tighten the impact member mount according to the marking made during removal.

-- Install the headlamp housing mount. Refer to OVERVIEW - HEADLAMP HOUSING MOUNT (VEHICLES THROUGH MY 2012) .

-- Install the impact member. Refer to IMPACT ABSORBER, REMOVING AND INSTALLING, VEHICLES FROM MY 2013 .

scientia non olet · About LEMON Manuals