Front Noise Insulation

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

Noise Insulation
- Removing:
- The front wheel spoiler is removed. Refer to FRONT WHEEL SPOILER, ASSEMBLY OVERVIEW .
  -- Remove the screws -1- and -2-, as well as the lower wheel housing screws (three on each side) and remove the noise insulation under the bumper.
- When installing, slide the front noise insulation in under the bumper.
  NOTE:
  Make sure that the exhaust pipe is correctly routed through the noise insulation for vehicles with auxiliary heater.
Bolt
- 5 Nm
- Quantity: 2
Quick Release
- Rotate 180° to the left to remove.
- When installing, the connection must engage when rotating.
Washer
Rear Noise Insulation
Lock Carrier

Vehicles with Auxiliary Heating

Fig 2: Identifying Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- For vehicles with auxiliary heater, the exhaust pipe opening -arrow- must run vertically through the grommet in the noise insulation.