Wheel Covers, Removing And Installing: Notes

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Roller 3356
Gauge - Gap Adjustment 3371
Front and Rear Door Template T40038/8

NOTE:

The attached trim can only be replaced, removal without destruction is not possible.

Remove adhesive residue on body if necessary.

The adhesive surfaces must free of dust and grease. Clean with Cleaning Solution -D 009 401 04-.

Apply Bonding Agent -D 355 205 A2- to the surface using the Applicator -D 009 500 25- on the body-side and let it dry for 10 minutes.

When installing, the trim must be applied according to the contours. It is not possible to make corrections later.

Press the covers with the Roller 3356 after installation.

For Fender Wheel Cover, Refer to Fender Wheel Cover .

For Side Panel Wheel Cover, Refer to Side Panel Wheel Cover .