Vehicles with 6-cylinder engine
WARNING: This page is about a different car, the 2002 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Removing
- Remove front right wheel.
- Remove generator. Refer to Removing .
- Remove heat shield for right drive shaft -arrows-.
- Disconnect cable for terminal B+ -2-.
- Disconnect connector for terminal 50 -1-.
- Remove heat shield -3- from solenoid switch.
- Remove starter mounting bolts -arrows-, detach starter.
Installing
Installation is reverse of removal, paying attention to the following:
- Install generator. Refer to Installing , observe instructions for connecting battery.
Tightening torques
| Component | Nm | |
| Starter to engine | 45 | |
| Terminal B+ to starter | 16 | |
| Heat shield for drive shaft to transmission | 23 | |