Vehicles with 3.0 L 6-cylinder engine: Installing

WARNING: This page is about a different car, the 2002 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Installation is reverse order of removal, pay attention to the following:

Fig 1: Identifying Belt Path

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Make sure the ribbed belt is seated and installed correctly.

1 - Generator

2 - Ribbed belt

3 - Power steering vane pump

4 - A/C compressor

5 - Crankshaft

6 - Tensioner roller

Start engine and check belt running.

Tightening torques

Component		Nm
Generator to engine	M8	22
	M10	45
Terminal 30/B+ to generator		16
Bracket for refrigerant line to oil pan		10
Bracket for starter wire to engine console		10