Steering column switch module, removing and installing: Installing
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal, noting the following:
- Ensure all fasteners and electrical connectors are properly connected and locked into place.
- Insert upper steering column trim in hooks for bottom trim, press both sections together and tighten screws.
- Install steering wheel and drivers airbag → 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS .
Tightening torques
| Component - fastener | Nm |
| Steering column switch module - bolt | 3 |
| Trim for steering column switch - screw | 1 |