Right Temperature Flap Motor V159, removing and installing: Installing

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The control motor lever is color-coded. The lever for the Right Temperature Flap Motor V159 is dark purple

Reinstall all parts removed in reverse order, paying attention to the following:

Lay wiring harness such that it cannot come into contact with moving components (e.g. control motor lever).
Check → Diagnostic Trouble Code (DTC) Memory, checking (function 02) and erase DTC memory → Diagnostic Trouble Code (DTC) Memory, erasing (function 05) ; perform basic setting → Basic Setting (function 04) .

NOTE:

Operation of the control motor can be checked as follows: Connect the two contacts "5" and "6" in the control motor connector to a 12V DC source. The control motor moves as far as the stop in one direction. Interchanging positive and negative reverses direction. Use adapter for this purpose → Adapter cable, modifying to activate positioning motors .