Condenser, removing and installing: Removing
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Discharge refrigerant circuit → Discharge refrigerant circuit .
- Remove refrigerant lines from condenser → Refrigerant lines for condenser, removing and installing .
- Remove air guides between bumper and condenser.
- If applicable, unfasten or remove power steering cooler (not always necessary, depends on vehicle) → 48 - STEERING
- If applicable, unfasten or remove Coolant Fan Control (FC)Control Module J293 (not always necessary, depends on vehicle) →
- 19 - ENGINE - COOLING SYSTEM for 1.8 LITER 4-CYL. 5V TURBO ENGINE MECHANICAL, ENGINE CODE(S): AMB
- 19 - ENGINE - COOLING SYSTEM for 2.0 LITER 4-CYL. 4V TURBO ENGINE MECHANICAL, ENGINE CODE(S): BPG, BWT
- 19 ENGINE - COOLING SYSTEM for 3.0 LITER 6-CYL. 5V ENGINE MECHANICAL, ENGINE CODE(S): AVK, BGN
- 19 - ENGINE - COOLING SYSTEM for 3.2 V6 4V ENGINE MECHANICAL, ENGINE CODE(S): BKH
- 19 - ENGINE - COOLING SYSTEM for 4.2 LITER V8 4V ENGINE MECHANICAL, ENGINE CODE(S): BNS
- 19 - ENGINE - COOLING SYSTEM for 4.2 LITER V8 5V ENGINE MECHANICAL, ENGINE CODE(S): BHF
- Disconnect connector from High Pressure Sensor G65 - B -.
- Remove bolts - A - (tightening torque 5 Nm).