Handle for variable convertible top compartment, removing and installing

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Remove handle mount trim → Handle mount trim, assembly overview .

NOTE:

Illustration shown from rear for greater clarity.

Fig 1: Identifying Fuse, Pin, Handle & Bowden Cable

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Using a small flat screwdriver, pry out fuse - 2 - (always replace fuse - 2 -).
Press out pin - 3 -.
Remove handle - 1 -.

1 - Handle

2 - Fuse

- Always replace

3 - Pin

4 - Bowden cable

Installing

Installation is in reverse order of removal.