Assembly overview
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Windshield
- Removing → Removing
- Installing → Preparing for window installation
- Distance to roof dimension - a - = 6 mm +0. 5 mm
- Align distance - d - at sides.
NOTE:
- Stickers on windshield (e.g. for airbag) must be replaced in same position on new windshield.
2 - Adhesive bead
- Observe curing times → Minimum curing times!
- Note varying spacing dimensions to window edge.
- Distances of top and side window edge dimension - b - and dimension - d - = 4 mm
- Distance at lower window edge measured from inner side of clip dimension - c - = 10 mm.
- Bead cross section
- Bead width = 8 ± 2 mm
- Bead height = 13.5 +1.5 mm
3 - Spacers
- 5x
- Affix in regular intervals to retaining strip
4 - Protective piping
- Only installed as new part.
- Only remove after installing windshield and before installing plenum chamber cover
5 - Plenum chamber cover
- Pull protective piping - 4 - from retaining strip before installing plenum chamber cover.
- Press into fastening strip only after window adhesive curing time has elapsed.