Minimum curing times!
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- For safety reasons, use only electrically non-conductive 2C-adhesive when installing windshield and rear window using the materials listed below.
- Vehicle is only safe for operation after minimum curing time has elapsed and only then may it be used.
| Window | Vehicle | Adhesive sealing material | Curing time in hours |
|---|---|---|---|
| Windshield | With airbag | DA 004 600 A2 | 3 |
| Rear window | DA 004 600 A2 | 3 | |
| Side window | DH 009 100 03 | 3 |
Cleaning when soiled by adhesive sealing material
Adhesive removal solution D 002 000 10 is the recommended cleaning solution. Observe safety precautions when processing.
CAUTION:
When cleaning from vehicle interior out, the window just installed must not be pressed outward.
Paint surfaces:
- First, clean paint surfaces with a dry cloth. Remove further material using adhesive removal solution D 002 000 10.
Plastic trim:
- Allow adhesive sealing material to harden (about 1 hour) and then peel off.