Lock carrier, service position: Notes
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Do not remove noise insulation, only loosen front quick release screws → Noise insulation panel - assembly overview .
- Bumper removed.
1 - Lock carrier
- Service position
- Unscrew intake air duct between lock carrier and air cleaner housing at lock carrier and remove.
- On the left side, screw in special tool 3369 in threaded hole Screw in special tool 3369
- On the right side, screw in special tool 3369.
- Unscrew mounting bolts - 5 - at left and right.
- Unscrew mounting bolts - 4 - and pull lock carrier - 1 - toward front.
- Secure lock carrier Secure lock carrier .
2 - Left engine cover
3 - Right engine cover
4 - Combination bolt
- 10 Nm
5 - Combination bolt
- 50 Nm
- For service position, screw in special tool 3369.
NOTE:
- After assembly of lock carrier, check headlight positioning and adjust if necessary.