Noise insulation panel - assembly overview
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Quick release screw
- Remove only these quick release screws for service position of lock carrier.
- 3 pieces
2 - Noise insulation, front
3 - Wheel spoiler
4 - Quick release screw
- 3 pieces
5 - Noise insulation panel rear
- Only installed for certain motor types
6 - Quick release screw
- Two pieces
7 - Noise insulation panel mount
- Marking (recess) must point to left vehicle side.
8 - Bolt
- Two pieces
- 7 Nm
9 - Speed nut
- 3 pieces
10 - Speed nut
- Two pieces
11 - Clamping pin
- Six pieces
12 - Wheelhousing liner
13 - Bumper
14 - Lock carrier with attachments