Rear axle camber, adjusting

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Wheel Bearing Housing/Transverse Link Connection Nut & Adjusting Camber

GW00019972

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove wheel bearing housing/transverse link connection nut - A -.
Adjust camber by turning eccentric bolt - B -.

NOTE:

The maximum adjustment range is 90° to left or right of center position.
For a better illustration, camber adjustment is shown with wheel removed.

Install new nut - A - and tighten
After tightening nut - A - , check camber value again → Specifications for wheel alignment .