Driveshaft, disconnecting from rear final drive: Notes

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

See notes → Driveshaft, servicing overview
The driveshaft should only be worked on a two column lift.

Fig 1: Locating Clamping Sleeves And Removing Rear Part Of Exhaust System

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Loosen clamping sleeves - 1 - and - 2 - and remove rear part of exhaust system →
- 26 - EXHAUST SYSTEM, EMISSION CONTROLS for 1.8 LITER 4-CYL. 5V TURBO ENGINE MECHANICAL, ENGINE CODE(S): AMB
- 26 - EXHAUST SYSTEM, EMISSION CONTROLS for 2.0 LITER 4-CYL. 4V TURBO ENGINE MECHANICAL, ENGINE CODE(S): BPG, BWT
- 26 EXHAUST SYSTEM, EMISSION CONTROLS for 3.0 LITER 6-CYL. 5V ENGINE MECHANICAL, ENGINE CODE(S): AVK, BGN
- 26 - EXHAUST SYSTEM, EMISSION CONTROLS for 3.2 V6 4V ENGINE MECHANICAL, ENGINE CODE(S): BKH
- 26 - EXHAUST SYSTEM, EMISSION CONTROLS for 4.2 LITER V8 4V ENGINE MECHANICAL, ENGINE CODE(S): BNS
- 26 - EXHAUST SYSTEM, EMISSION CONTROLS for 4.2 LITER V8 5V ENGINE MECHANICAL, ENGINE CODE(S): BHF
.
Check whether there is a marking (colored marking) on driveshaft and at flange/driveshaft at rear final drive.

Fig 2: Identifying Mark Position Of Driveshaft Flange To Rear Final Drive

Courtesy of VOLKSWAGEN UNITED STATES, INC.

If this marking is not present, then mark in color the position of driveshaft flange - arrow A - to rear final drive - arrow B -.

Fig 3: Removing/Installing Mounting Bolts On Rear CV Joint And Driveshaft

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove mounting bolts - arrows - on rear CV joint with parking brake engaged and remove driveshaft.

Fig 4: Disconnecting Driveshaft From Rear Final Drive And Tie Up To Side

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect driveshaft from rear final drive and tie up to side - arrow -.