Selector mechanism cover, selector lever handle, component overview
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2009 Audi A4, 2008 Audi S4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Lubricate all bearings and moving surfaces with polycarbamide grease G 052 142 A2 .
1 - Selector lever
2 - Sleeve for selector lever
- Removing and installing → Selector lever handle, removing and installing
3 - Selector lever handle
- Removing and installing → Selector lever handle, removing and installing
4 - Cover
- With position indicator and Tiptronic gate and display for selector lever lock
- Removing and installing → Selector mechanism cover, removing and installing
5 - Symbol insert
- Clipped onto cover
6 - Printed circuit board
- With integrated Tiptronic switch F189
- Removing and installing → Tiptronic switch F189, removing and installing
7 - Sliding cover
- With integrated magnet for Tiptronic switch F189 on transverse slide.
- Removing and installing → Tiptronic switch F189, removing and installing
8 - Guide for sliding cover
- Carefully pry apart two halves