O-ring at cover for final drive, replacing: Removing

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Wheel Hex Bolt

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Loosen bolt drive axle/wheel hub while the vehicle is still standing on its wheels. → 40 - FRONT SUSPENSION
Remove right wheel.
Remove heat shield for right drive axle.
Remove right drive axle: → 40 - FRONT SUSPENSION

Remove right front exhaust pipe. →
- 26 - EXHAUST SYSTEM, EMISSION CONTROLS for 1.8 LITER 4-CYL. 5V TURBO ENGINE MECHANICAL, ENGINE CODE(S): AMB
- 26 - EXHAUST SYSTEM, EMISSION CONTROLS for 2.0 LITER 4-CYL. 4V TURBO ENGINE MECHANICAL, ENGINE CODE(S): BPG, BWT
- 26 EXHAUST SYSTEM, EMISSION CONTROLS for 3.0 LITER 6-CYL. 5V ENGINE MECHANICAL, ENGINE CODE(S): AVK, BGN
- 26 - EXHAUST SYSTEM, EMISSION CONTROLS for 3.2 V6 4V ENGINE MECHANICAL, ENGINE CODE(S): BKH
- 26 - EXHAUST SYSTEM, EMISSION CONTROLS for 4.2 LITER V8 4V ENGINE MECHANICAL, ENGINE CODE(S): BNS
- 26 - EXHAUST SYSTEM, EMISSION CONTROLS for 4.2 LITER V8 5V ENGINE MECHANICAL, ENGINE CODE(S): BHF
Remove right transmission support → Right and left transmission mounts, removing and installing .

Fig 2: Flange Shaft Bolt

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolt for flange shaft (arrow) while securing against turning using a drift.
Place drip tray VAG1306 underneath.
Remove right drive flange.

Fig 3: Installing Cover For Front Final Drive, Tightening Sequence

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolts for final drive cover opposite of shown tightening sequence and remove cover.