Shift mechanism, removing and installing: Installing

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Installation is reverse of removal, noting the following:

Install selector lever cable.

Fig 1: Inserting End Of Selector Lever Cable Into Joint Of Selector Lever

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fit new retaining clip - 1 - for selector lever cable on shift mechanism.

Installation position:

Angled end of retaining clip faces to inside of shift mechanism.

Install locking cable Installing .
Adjust locking cable → Locking cable, adjusting .
Fit driveshaft to transmission. →
- 39 FINAL DRIVE, DIFFERENTIAL for REAR FINAL DRIVE
- 39 - FINAL DRIVE, DIFFERENTIAL for REAR FINAL DRIVE 0AR
Install front exhaust system with catalytic converter. →
- 26 - EXHAUST SYSTEM, EMISSION CONTROLS for 1.8 LITER 4-CYL. 5V TURBO ENGINE MECHANICAL, ENGINE CODE(S): AMB
- 26 - EXHAUST SYSTEM, EMISSION CONTROLS for 2.0 LITER 4-CYL. 4V TURBO ENGINE MECHANICAL, ENGINE CODE(S): BPG, BWT
- 26 EXHAUST SYSTEM, EMISSION CONTROLS for 3.0 LITER 6-CYL. 5V ENGINE MECHANICAL, ENGINE CODE(S): AVK, BGN
- 26 - EXHAUST SYSTEM, EMISSION CONTROLS for 3.2 V6 4V ENGINE MECHANICAL, ENGINE CODE(S): BKH
- 26 - EXHAUST SYSTEM, EMISSION CONTROLS for 4.2 LITER V8 4V ENGINE MECHANICAL, ENGINE CODE(S): BNS
- 26 - EXHAUST SYSTEM, EMISSION CONTROLS for 4.2 LITER V8 5V ENGINE MECHANICAL, ENGINE CODE(S): BHF