Assembly sequence: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Torsen housing, torsen differential, transmission cover, transmission-side shift mechanism, input shaft, drive pinion and hollow shaft, removing and installing.
NOTE:
- You do not need to remove the differential when removing the components listed above.
- Removal is only necessary when adjustments have to be performed → Adjustment overview .
Fig 1: Identifying Special Tools - Torsen Housing, Torsen Differential, Transmission Cover, Transmission-Side Shift Mechanism, Input Shaft, Drive Pinion And Hollow Shaft, Removing And Installing (1 Of 2)
Special tools, testers and auxiliary items required
- Holding plate VW 309
- Transmission support VW 353
- Tube VW 415 A
- Tube VW 421
- Slide Hammer-Complete Set VW 771
- Driver 32 - 111
Fig 2: Identifying Special Tools - Torsen Housing, Torsen Differential, Transmission Cover, Transmission-Side Shift Mechanism, Input Shaft, Drive Pinion And Hollow Shaft, Removing And Installing (2 Of 2)
Special tools, testers and auxiliary items required
- Thrust piece 40 - 105
- Drive bushing 41 - 501
- Torque wrench V.A.G 1331
- Torque wrench V.A.G 1332
- Puller T40054
- - 1 - Two arm puller Kukko 20/10
- - 2 - Puller hooks, 250 mm long
- Feeler gauge
- Sealing paste AMV 188 001 02
- Assembly sleeve 01E 311 120
- Thread locking compound AMV 185 101 A1
- Sealing grease G 052 128 A1
- Depth gauge, e.g. Digital Depth Gauge VAS 6087
- Oil receptacle
Special tools, testers and auxiliary items required
- Socket and key T40097