Disassembling and assembling sequence: Notes
WARNING: This page is about a different car, the 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Removing and installing ball bearing for input shaft, selector shaft, transmission cover and bearing housing with input shaft and pinion shaft.
Special tools, testers and auxiliary items required
- Drift sleeve VW 244 B
- Thrust plate VW 401
- Thrust plate VW 402
- Thrust disc VW 412
- Tube 60 mm dia. VW 415 A
- Thrust pad con. VW 433
Special tools, testers and auxiliary items required
- Sleeve VW 519
- Holding fixture VW 540
- Press tube 30 - 23
- Press tool 40 - 21
- Sleeve 40 - 103
- Thrust piece 40 - 105
Special tools, testers and auxiliary items required
- Drift sleeve 41 - 501
- Transmission support 2004
- Mandrel 2064
- Thrust piece 3002
- Door hinge alignment tool (M8 and M10) 3114/2
- Fitting tool T10246
Special tools, testers and auxiliary items required
- Repair press V.A.G 1290 A
- Drip tray V.A.G 1306
- Torque wrench V.A.G 1331
- Torque wrench V.A.G 1332
- Taper roller bearing puller V.A.G 1582
- Adapter V.A.G 1582/12
- - 1 - Internal puller Kukko 21/2
- - 2 - Puller Kukko 18/2
Special tools, testers and auxiliary items required
- Removal plate T40086
- Holding plate T40088/1
- - 1 - Two-arm puller Kukko 20/10
- - 2 - Puller hook, length 200 mm
- - 2 - Puller hook, length 250 mm
- Feeler gauge
- 2 bolts M8 (length 70 mm) with washers
- Sealing paste AMV 188 001 02
- Assembly sleeve 01E311120
- Locking fluid AMV185101A1