Back-up light switch F4, removing and installing

WARNING: This page is about a different car, the 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Identifying Torque Wrench V.A.G. 1331

GW00000113

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Torque wrench V.A.G 1331

Fig 2: Front And Rear Sound Insulation And Fasteners

GW00018916

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing

If installed, loosen quick release fasteners - 3 - and remove rear sound insulation - B -.

Fig 3: Back-Up Light Switch F4 Electrical Connector

GW00017877

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connector - arrow - for back-up light switch F4 on transmission (right side).

Fig 4: Removing Back-Up Light Switch F4 From Selector Shaft Cover

GW00019033

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove back-up light switch F4 from selector shaft cover - arrow -.

Fig 5: Removing Back-Up Light Switch F4 From Selector Shaft Cover

GW00019033

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installing

Screw back-up light switch F4 into selector shaft cover - arrow -.

Fig 6: Back-Up Light Switch F4 Electrical Connector

GW00017877

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Attach electrical connector - arrow - for back-up light switch F4 on transmission (right side).

Component	Nm
Back-up light switch F4	20