Clutch pedal switch F36, removing and installing: Notes

WARNING: This page is about a different car, the 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Clutch pedal switch F36 may only be installed once so as to ensure a firm fit.

Removing

Remove storage compartment on drivers side →
- 68 - INTERIOR EQUIPMENT
- 68 - INTERIOR EQUIPMENT for Cabriolet
.

Fig 1: Identifying Pedal Assembly And Clutch Pedal Switch F36

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connector - 1 - on clutch pedal switch.

The clutch pedal - 3 - is in the normal position (i.e. not pressed down). The operating rod - arrow - of the clutch pedal switch F36 should then rest against the clutch pedal.

Release clutch pedal switch F36 - 2 - by turning 45° counter-clockwise and remove from guide.

Installing

Fig 2: Pulling Out Switch Plunger & Identifying Retainer Tabs On Switch

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installation is perform in reverse sequence. Note the following:

Pull out operating rod - arrow - all the way before installing clutch pedal switch F36.

Fig 3: Identifying Clutch Pedal Switch F36, Plunger

Courtesy of VOLKSWAGEN UNITED STATES, INC.

The clutch pedal should be in the normal position (i.e. not pressed down).

Guide clutch pedal switch F36 through mounting hole, press against clutch pedal and attach by turning 45° clockwise.
Plug in connector for clutch pedal switch F36.
Install storage compartment on drivers side →
- 68 - INTERIOR EQUIPMENT
- 68 - INTERIOR EQUIPMENT for Cabriolet
.