Selector shaft, disassembling and assembling: Notes

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Selector Shaft, Completely Disassembling And Assembling

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Selector cylinder

2 - Spring pin

Removing and driving in flush. See Removing and installing spring pin flush
Installation position of spring sleeve: Slot longitudinal to line of force

3 - Selector shaft

Tapping out. See Driving out selector shaft
Tapping in. See Driving in selector shaft
Installation position: Flat (arrow) and selector finger -Item 4 face in same direction

4 - Selector finger

Observe installation position to -Item 3

5 - Toggle for reversing light switch