Detaching slave cylinder from hose/pipe assembly

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Hydraulic Line From Slave Cylinder

GW00005234

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing

To remove the hose/pipe assembly, lever out the clip -A- up to the stop using a screwdriver. Only then can the hose/pipe assembly be pulled out.

Installing

Press in clip -A- to stop.
Push hose/pipe assembly into slave cylinder until it engages audibly.
To check, pull on the hose/pipe assembly.