Radiator, removing and installing: Removing
WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, and 2003 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Remove front bumper: →
- 63 BUMPER
- 63 - BUMPERS for CABRIOLET
- Drain coolant → Cooling system, draining and filling .
- Remove coolant hose couplers from top and bottom of radiator.
- Remove air ducts on left and right of radiator - arrows -.
- Disconnect connector - 1 - from A/C pressure switch F129.
- Disconnect connector - 2 - from ambient temperature sensor.
- Move both wires clear.
CAUTION:
Air conditioner refrigerant circuit must not be opened.
- Unbolt condenser - arrows - from radiator.
NOTE:
- To prevent damage to condenser and refrigerant lines/hoses ensure that lines and hoses are not stretched, kinked or bent.
- Carefully swivel condenser downward and set down.
- Release two retaining bolts for radiator and pull out upward - arrows -.
- Swivel radiator forward out of lock carrier and lift out.