Speedometer Vehicle Speed Sensor (VSS) -G22-, removing and installing
WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Removing
- Pull connector off sensor -A-.
- Press retaining clip down, turn sensor sideways and pull out upward.
Installing
- Replace O-ring -B- during installation.
- Insert sensor and click into place.
- Handle sensor carefully. If damaged it is possible that speedometer will not be accurate.