Performing check measurement
WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- After installing shims "S1" and "S2", turn differential 5 turns in both directions so that tapered roller bearings settle.
- Measure backlash four times on circumference.
- Specification: 0.12... 0.22 mm
NOTE:
- If the backlash is beyond the tolerance, the adjustments must be repeated. The total shim thickness "Stotal" must not be changed when the adjustment is repeated.
- The individual measurements must not differ by more than 0.06 mm from each other.