Input shaft ball bearing and multi-function sensor, removing and installing: Notes
WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Transmission housing
- With differential and flange shafts
- Removing and installing flange shafts. Refer to Flange shaft oil seal, replacing
- Removing and installing differential. Refer to Differential, removing and installing
- Removing and installing speedometer sensor and drive wheel. Refer to Speedometer sensor and drive wheel, removing and installing
- Breather installation position. See Installation position of breather
2 - Torx socket head bolt
- Self-locking
- Always replace
3 - Guide sleeve
- With O-ring and seal for input shaft. Refer to Clutch release mechanism, servicing
- Installation position: Oil drain hole points downward
4 - Dished washer
- Smaller diameter (convex side) to guide sleeve
5 - Circlip
- Determining thickness adjusting. Refer to Input shaft, adjusting
6 - Ball bearing
- Removing and installing. Refer to Ball bearing for input shaft, multi-function sensor, input shaft, drive pinion, selector rods and transmission cover, removing and installing
7 - Circlip
- Determining thickness adjusting. Refer to Input shaft, adjusting
8 - Input shaft
- Removing and installing. Refer to Figure
- Disassembling and assembling. Refer to Input shaft, disassembling and assembling
- Adjusting. Refer to Input shaft, adjusting
- Servicing input shaft bearings. Refer to Input shaft, disassembling and assembling
9 - Bolt
10 - Tab washer
- For multi-function sensor
11 - Multi-function sensor
12 - Connector for multi-function sensor
13 - Bolt - 10 Nm
14 - Cover for selector shaft
- Removing and installing. Refer to Shift mechanism in transmission, disassembling and assembling
15 - Locking module for 5th gear and reverse gear
- Removing and installing. Refer to Removing and installing locking module for 5th gear and reverse gear