Shift lever and rear push rod, servicing

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Shift Lever And Rear Push Rod Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

NOTE: Lubricate mountings and sliding surfaces with polycarbamide grease, part no. G 052 142 A2.

1 - Shift lever

Lubricate area around bottom hole with G 052 142 A2
Lubricate ball with G 052 142 A2 polycarbamide grease

2 - Spacer tube

Lubricate with G 052 142 A2 polycarbamide grease

3 - Circlip

Always replace

4 - Washer

Collar faces ball guide (item 6 Shift lever and rear push rod, servicing )

5 - Rubber ring

6 - Ball guide

Removing and installing. Refer to Shift lever with rear push rod, removing and installing

7 - Rubber ring

8 - Rear push rod

With ball housing
Removing and installing. Refer to Shift lever with rear push rod, removing and installing

9 - Bolt, 6 Nm

Qty. 4
For rear push rod - to shift lever housing