Installing The Output Shaft Ball Bearing -A- In The Transmission Housing

WARNING: This page is about a different car, the 2010 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Output Shaft Ball Bearing

Courtesy of AUDI OF AMERICA, LLC

-- Install the ball bearing locking ring paying close attention to the installed position of the locking ring INSTALLED POSITION: LOCKING RINGS -A- FOR THE BALL BEARINGS -B- .

Fig 2: Removing Input Shaft Ball Bearing -A- From Transmission Housing

Courtesy of AUDI OF AMERICA, LLC

Remove the ball bearing locking ring beforehand.