Overview - Oil Pan/Oil Pump: Notes
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
- Nut
- 9 Nm
- Oil Level Thermal Sensor -G266-
- Removing and installing. Refer to OIL LEVEL THERMAL SENSOR -G266-, REMOVING AND INSTALLING .
- Gasket
- Replace
- Oil Pan Lower Section
- Removing and installing. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
- Bolt
- 3 Nm +90°
- Replace
- Lower Oil Baffle
- Bolt
- Replace
- Tightening specification and sequence. Refer to Figure.
- Oil Pan Upper Section
- Removing and installing. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
- Alignment Sleeve
- Quantity: 2
- O-Ring
- Insert into guide frame
- Replace
- Bolt
- Insert with locking fluid. Refer to the Parts Information for the locking fluid.
- 9 Nm
- Upper Oil Baffle
- Seal
- Insert into guide frame
- Replace
- Seal
- Replace
- Bolt
- 3 Nm +90°
- Replace
- Engine Oil Cooler
- With oil cooler bypass valve
- See note. Refer to REMOVING .
- Removing and installing. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Oil Pump Input Shaft
- Pressure Spring
- Sleeve
- Quantity: 2
- Bracket
- Bolt
- 9 Nm
- Chain Sprocket for Oil Pump
- Can only be placed onto drive axle in one position
- Bolt
- 30 Nm +90°
- Replace
- For loosening and tightening, counterhold on the chain sprocket with a Wrench - Pin Type:3212
- O-Ring
- Replace
- Seal
- Replace
- O-Ring
- Replace
- Oil Pump
- Do not disassemble
- Removing and installing. Refer to OIL PUMP, REMOVING AND INSTALLING .
- Bolt
- 20 Nm
- Bolt
- Replace
- Tightening specification and sequence. Refer to Figure.
- Gasket
- Replace
- Oil Drain Plug
- 30 Nm