Electric Drive Power And Control Electronics -JX1-, Removing And Installing: Notes
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Torque Wrench 1331 5-50 Nm :VAG1331
- Hose Clamps - Up To 25mm:3094
- Contact Surface Cleaning Set:VAS6410
WARNING:
Read and follow the high voltage electrical system general warnings. Refer to HIGH VOLTAGE SYSTEM GENERAL WARNINGS .
NOTE:
Pay attention to the instructions for handling high voltage cables. Refer to GENERAL INFORMATION .
CAUTION:
The new electric drive power and control electronics must be protected before installing on the flange plates if the Electric Drive Power and Control Electronics -JX1- is being replaced. Refer to ELECTRIC DRIVE POWER AND CONTROL ELECTRONICS -JX1-, PROTECTING .