LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1261 (Charging System (Battery, Starter, Generator) & Cruise Control) >> 27 Battery, Starter, Generator, Cruise Control >> Starter, Vehicles With Automatic Transmission >> Starter, 3.0L TSI 213 Kw, Automatic Transmission Al8 >> Starter, 3.0L TSI 213 Kw, Automatic Transmission Al8, Removing And Installing >> Installing

Starter, 3.0L TSI 213 Kw, Automatic Transmission Al8, Removing And Installing: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following: 

-- Install the starter and install the new bolts.

NOTE:

If there is not enough space to use the :VAG156A  then mark the bolt head with a small dash. Tighten the bolt to the tightening specification.

-- Tighten the upper bolt that attaches the starter to the transmission to 30 Nm  and then to 105° ± 30° additional turn.

-- Tighten the lower bolt that attaches the starter to the transmission to 15 Nm  and then to 105° ± 30° additional turn.

-- Tighten the nut that attaches the positive cable to the solenoid switch to the tightening specification shown in the Assembly Overview. Refer to OVERVIEW - STARTER .

scientia non olet · About LEMON Manuals