Distance Regulation Control Module -J428-, Removing And Installing: Installing:

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following:

The Adaptive Cruise Control (ACC) sensors must be calibrated after:

Removing, installing or replacing a Distance Regulation Control Module -J428-,
Every removal and installation, and replacement of assembly carrier,
If there is a suspicion of forceful impact on these two parts, an accident during driving or similar.

Calibrating the distance regulation (ACC). Refer to DISTANCE REGULATION (ACC), CALIBRATING .

-- Adapt the ACC when first using or replacing the Distance Regulation Control Module -J428- or Distance Regulation Control Module 2 -J850-. Refer to AUTOMATIC DISTANCE REGULATION, INITIALIZING .

NOTE:

The stud bolts in the bracket are pre-set. Correct the setting only if necessary.

Replace the clip if the adjusting screw was removed. Refer to REMOVE THE CLIP ON THE DISTANCE REGULATION CONTROL MODULE -J428- "MASTER", DISTANCE REGULATION CONTROL MODULE 2 -J850- "SLAVE" .