Distance Regulation (Acc), Calibrating
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
The Adaptive Cruise Control (ACC) sensors must be calibrated after:
- Removing, installing or replacing a Distance Regulation Control Module -J428-,
- Every removal and installation, and replacement of assembly carrier,
- If there is a suspicion of forceful impact on these two parts, an accident during driving or similar.
- If toe and/or camber were adjusting during an axle alignment.
Adaptive cruise control sensor, aligning. Refer to Adaptive Cruise Control (ACC) .