Lower Control Arm, Repairing - Pressing The Bonded Rubber Mount In And Out, Caster Adjusting Bolt Connection: Installing
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note The Following:
The threaded connection of the shock absorber/lower control arm must be tightened in the curb weight position. Refer to LIFTING THE FRONT AXLE TO THE CURB WEIGHT POSITION .
-- Install the wheel and tighten. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .
-- Tighten the threaded connection of the lower control arm/subframe during the vehicle alignment.
-- Perform vehicle alignment. Refer to WHEEL ALIGNMENT .