Lifting The Front Axle To The Curb Weight Position

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Engine and Gearbox Jack:VAS6931
Tensioning Strap:T10038
Engine/Gearbox Jack Adapter - Wheel Hub Support:T10149

CAUTION:

All bolts at suspension parts with bonded rubber bushings must always be tightened in curb weight position (unloaded condition).

Bonded rubber bushings have a limited range of motion.

Axle components with bonded rubber bushings must be brought into the position they will be in during driving before tightening (curb weight position).

Otherwise, the bonded rubber bushing will have tension, which will reduce the service life.

By raising appropriate suspension using Engine and Gearbox Jack:VAS6931 and Engine/Gearbox Jack Adapter - Wheel Hub Support:T10149 , this position can be simulated on the hoist.

Before Lifting the Axle on One Side, the vehicle Must Be Secured on Both Sides to the Lift Arms of the Lift Using Tensioning Strap:T10038 .

WARNING:

The vehicle could fall off the hoist if it is not secured.

-- Turn the wheel hub until one of the holes for the wheel bolts is on top.

-- Install Engine/Gearbox Jack Adapter - Wheel Hub Support:T10149 with wheel bolt on wheel hub.

Tightening of the Respective Bolts/Nuts Must Then Only Occur After Dimension -a- Between The Wheel Hub Center and the Lower Edge of Wheel Housing Has Been Attained.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Dimension -a- is dependent on standing height of installed suspension:

Chassis ⁽¹⁾

Standing Height -a- in mm

Steel spring shock absorber 1BA/1BE

478 ± 10 mm

Steel spring shock absorber 1BB

488 ± 10 mm

Air spring shock absorber 1BK/1BY

475 ± 10 mm

Air spring shock absorber 2MA

450 ± 10 mm

⁽¹⁾	The suspension that the vehicle is equipped with is indicated on the vehicle data plate. Suspension is represented by PR number. To determine which PR number represents which suspension. Refer to VEHICLE DATA LABEL .

-- Lift the wheel bearing housing using the Engine and Gearbox Jack:VAS6931 until dimension -a- is reached.

WARNING:

Do not lift or lower vehicle with the engine and gearbox jack still under the vehicle.
Do not leave the Engine and Gearbox Jack:VAS6931 under the vehicle any longer than necessary.

-- Tighten the bolts and nuts.

-- Lower the wheel bearing housing.

-- Remove the Engine and Gearbox Jack:VAS6931 from under the vehicle.

-- Remove Engine/Gearbox Jack Adapter - Wheel Hub Support:T10149 .