Balance Shaft And Oil Pump Chain, Removing And Installing: Installing

Fig 1: Identifying Crankshaft Holder 3242

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

• Tightening specifications. Refer to OVERVIEW - BALANCE SHAFT AND OIL PUMP CHAIN .
• Secure crankshaft -1- in "TDC" position using Locking Pin For Crankshaft :T40237  .

-- Attach the rear balance shaft -arrow- to the engine using the Diesel Injection Pump Locking Pin:3359  .

Fig 2: Identifying Rear Balance Shaft -Arrow- And Diesel Injection Pump Locking Pin 3359

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the chain tensioner with the chain and the drive chain and the balance shaft chain sprocket.

• The slots in the chain sprocket -3- must be in the center position to the threaded holes in the balance shaft.

-- Tighten the chain tensioner bolts -1 and 2-.

Fig 3: Identifying Chain Tensioner, Drive Chain, And Balance Shaft -3- Chain Sprocket

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the chain sprocket bolts -arrows- loosely.

Fig 4: Identifying Chain Sprocket Bolts -Arrows-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

• It must still be possible to rotate the chain sprocket on the balance shaft and it must not tip.

-- Remove the drill from the alignment hole.

Fig 5: Push A Screwdriver In The -Direction Of The Arrow-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push a screwdriver in direction of -arrow- against the chain tensioner guide rail while tightening the chain sprocket bolts -1-.

-- Remove the Diesel Injection Pump Locking Pin:3359  from the balance shaft.

Install in reverse order of removal. Note The Following: 

-- Install the timing chain covers. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .

-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- Fill the engine oil and check the level. Refer to appropriate service information