LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1245 (Crankshaft, Cylinder Block [CATA]) >> 13 Crankshaft, Cylinder Block >> Chain Drive >> Overview - Balance Shaft And Oil Pump Chain

Overview - Balance Shaft And Oil Pump Chain

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exploded View Of Balance Shaft And Oil Pump Chain With Components
GWWA13-10547Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. Power Take-Off Drive Chain
  2. Drive Sprocket for Oil Pump
    • Installed position: the side with lettering on it faces the engine
  3. Bolt
    • 62 Nm
    • If it is not possible to tighten the bolt to the specification, remove the oil pan lower section and the oil baffle and counterhold the bolt with an open end wrench on the oil pump driveshaft.
  4. Thrust Washer
  5. Pressure Spring
  6. Crankshaft
  7. Bolt
    • 23 Nm
  8. Balance Shaft Chain Sprocket
    • Installed position: the side with lettering on it faces the transmission
  9. Bolt
    • 9 Nm
    • Quantity: 4
  10. Chain Tensioner
    • With glide track
  11. Seal
    • Replace
scientia non olet · About LEMON Manuals